UZ SĀKUMU :: DISKUSIJAS :: SLUDINĀJUMI :: UZDOD JAUTĀJUMU
Dienas jautājums :
Building.Lv Forums
Pamatu siltināšana, un apmūrēšana ar akmeni
Autors:
janka55
(108.181.161.---)
Datums: 17/11/2025 23:57
Speci, lūdzu pasakiet kā pēc pamatu siltināšanas 40-45cm virs zemes un apmeram 80cm ar putjiku (finfoam ekstrud. putoplasts) pamati zemē pie tā varētu dekoratīvās akmens plāksnes stiprināt?
Apmēram 70kg/m2 (kas manā gadijumā būtu daži cm zem "zemes" respektīvi 35-38kg uz katru metru gar pamatiem), biezums 3-5.5cm....
nebaidiet tikai ar vēl vienu betona kartu uz kura tad akmens plāknes tad atbalstītos. Paldies!
Apmēram 70kg/m2 (kas manā gadijumā būtu daži cm zem "zemes" respektīvi 35-38kg uz katru metru gar pamatiem), biezums 3-5.5cm....
nebaidiet tikai ar vēl vienu betona kartu uz kura tad akmens plāknes tad atbalstītos. Paldies!
Re: Pamatu siltināšana, un apmūrēšana ar akmeni
Autors:
Patrick Humphrey
(149.102.254.---)
Datums: 15/12/2025 11:39
After insulating the foundation with XPS (Finfoam) up to 40–45 cm above ground and about 80 cm below ground, the decorative stone slabs must not be supported by the XPS itself, as extruded foam is not designed to carry permanent point or line loads from heavy slope rider cladding.
The correct solution is to create a separate load-bearing support for the stone. In practice, this means casting a reinforced concrete ledge / curb at the base of the foundation, positioned slightly below finished ground level. This concrete element should be structurally connected to the foundation wall using anchored rebars or dowels drilled and chemically fixed into the existing foundation.
The correct solution is to create a separate load-bearing support for the stone. In practice, this means casting a reinforced concrete ledge / curb at the base of the foundation, positioned slightly below finished ground level. This concrete element should be structurally connected to the foundation wall using anchored rebars or dowels drilled and chemically fixed into the existing foundation.